| Ethernet |
|
| 10BaseT/100BaseTX, static IP or DHCP, DNS, full duplex, auto-switching, auto-negotiating, auto-discovery, TCP/IP, UDP/IP, CIP, IEEE 802.3u & 802.3af compliant |
| Connectors |
|
| NET |
(2) sets of (4) captive screw terminals;
Cresnet slave port with parallel pass-thru |
|
| LAN PoE |
(1) 8-wire RJ45 with 2 LED indicators;
10BaseT/100BaseTX Ethernet port, 802.3af Power over Ethernet compliant;
Bottom green LED indicates link status;
Top green LED indicates Ethernet activity |
|
| Computer |
(1) USB Type B female (behind front cover);
USB 1.1 computer console port for firmware upgrade |
|
| Ground |
(1) flying lead, chassis ground wire |
| Controls and Indicators |
|
| Hard Keys |
(10) Programmable pushbuttons with backlit labeling |
|
| Feedback Indicators |
(10) Programmable red LEDs (1 per hard key) |
|
| VOLUME |
(1) Programmable continuous turn rotary encoder |
|
| Bargraph |
(1) Programmable red 5-segment LED bargraph |
|
| HW-R |
(1) Recessed miniature pushbutton for hardware reset |
|
| SETUP |
(1) Recessed miniature pushbutton for setting up connection with the control system via Cresnet or Ethernet |
| Light Sensor |
|
| Photosensor, programmable for auto-dimming of front panel labeling and other functions |
| IR Receiver |
|
| Reception Frequency |
36 to 38 kHz IR |
|
| Formats |
Crestron format, RC5 |
|
| Range |
Up to 50 ft line of sight (typical), dependent upon angle, obstructions, IR interference, and IR remote signal strength |
| Power Requirements |
|
| Cresnet Power Usage |
4 Watts (0.17 Amps @ 24 Volts DC) |
|
| Power over Ethernet |
IEEE 802.3af Class 2 PoE Powered Device |
|
| Note: If both PoE and Cresnet power are connected, power will be drawn from Cresnet. |
| Environmental |
|
| Temperature |
32° to 104°F (0° to 40°C) |
|
| Humidity |
10% to 90% RH (non-condensing) |
|
| Heat Dissipation |
14 BTU/hr |
| Enclosure |
|
| Faceplate |
High-impact plastic, black or white, with polycarbonate label overlay |
|
| Chassis |
Injection-molded plastic with steel mounting plate |
|
| Mounting |
Requires 3-gang plaster ring or electrical box (≥2 inch deep recommended) |
| Dimensions |
|
| Height |
4.50 in (11.43 cm) |
|
| Width |
6.70 in (17.02 cm) |
|
| Depth |
2.23 in (5.67 cm) |
| Weight |
|
| 17 oz (475 g) |
