| Wireless Communications |
|
|
RF |
2.4 GHz ISM Device; 79 Channels FHSS (2402 to 2480 MHz) |
|
|
IR |
38 kHz |
|
|
Range (typical) |
50 ft (15 m) indoor, subject to site-specific conditions |
| Wired Communications |
|
|
USB |
USB host port for firmware update and configuration |
| Audio |
|
|
A-D/D-A Conversion |
16-bit, 44.1kHz |
|
|
Master Volume Range |
-55dB to +20dB |
|
|
Bass Gain Range |
±15dB @ 100Hz |
|
|
Treble Gain Range |
±15dB @ 10kHz |
|
|
Ducking Adjustment |
Software adjustable Threshold, Depth, Attack, and Release |
|
|
Alert Tone |
Software configurable functionality |
|
|
Frequency Response |
20Hz to 20kHz ±0.5dB |
|
|
S/N Ratio |
75dB 20Hz to 20kHz A-weighted |
|
|
THD+N |
0.7% 20Hz to 20kHz |
|
|
Output Power |
15 Watts per channel at 8 or 4 Ohms |
|
|
Amplifier Protection |
Electronic short-circuit and overload protection |
| Connectors – MP-FS-RX1 Receiver |
|
|
COMPUTER |
(1) USB Type B female;
USB service port |
|
|
BEACON SENSOR 1 – 2 |
(2) 3-pin 3.5mm detachable terminal blocks;
Interface for up to two MP-FSIR IR Beacon Sensors (1 included) |
|
|
MUTE SENSOR |
(1) 2-pin 3.5mm detachable terminal block;
Contact closure sensing input, or interface for MP-FS-PAS PA Audio Sensor[1];
Mutes all audio outputs when a contact closure or PA audio signal is sensed |
|
|
ALERT OUT |
(1) 2-pin 3.5mm detachable terminal block;
Normally open isolated relay, software configurable functionality;
Rated 2 Amp, 50 Volts maximum |
|
|
LINE IN 1 – 2 |
(4) RCA female comprising (2) unbalanced stereo line-level audio inputs;
Maximum Input Level: 2 Vrms;
Input Impedance: 18k Ohms nominal |
|
|
LINE OUT |
(2) RCA female, unbalanced stereo line-level audio output;
Maximum Output Level: 2 Vrms;
Output Impedance: 100 Ohms nominal |
|
|
SPEAKER OUT 4/8Ω |
(2) 2-pin 5mm detachable terminal blocks;
Left & right channel speaker-level audio outputs;
Wire Size: Connector accepts 14 AWG maximum;
Output Power: 15 Watts per channel at 8 or 4 Ohms |
|
|
G |
(1) 6-32 screw, chassis ground lug |
|
|
24VDC 2.0A |
(1) 2.1mm barrel DC power jack;
24 Volt DC power input (PW-2420RU power pack included) |
|
|
Antenna (front) |
(1) Connection for supplied antenna |
| Connectors – MP-FSIR IR Beacon Sensor |
|
|
T,R,S |
(1) 3-pin captive terminal block;
Interface to MP-FS-RX1 Receiver |
| Connectors – MP-FSMIC Microphone |
|
|
USB |
(1) 8-pin mini USB Type B female;
For factory use only |
| Connectors – MP-FSDS2 Docking Station |
|
|
5VDC 1.2A |
(1) 1.3mm barrel DC power jack;
5 Volt DC power input (PW-0510WU power pack included) |
| Controls & Indicators – MP-FS-RX1 Receiver |
|
|
PWR |
(1) green LED, indicates operating power supplied from external power pack |
|
|
BASS |
(1) rotary low frequency boost/cut adjustment |
|
|
TREBLE |
(1) rotary high frequency boost/cut adjustment |
|
|
MASTER VOLUME |
(1) rotary master level adjustment |
| Controls & Indicators – MP-FSMIC Microphone |
|
|
IR Beacon |
(2) infrared LEDs, transmit operation data to MP-FSIR IR Beacon Sensor(s) |
|
|
Status |
(1) dual-color green/red LED, indicates operational status and battery/charging condition |
|
|
ON/MUTE |
(1) rocker button, turns wireless mic on and off, and mutes mic audio |
|
|
VOL |
(1) rocker button, adjusts mic volume when mic is unmuted, adjusts program (line) volume when mic is muted |
|
|
ALERT |
(1) pushbutton, triggers ALERT OUT relay and/or alert tone |
| Controls & Indicators – MP-FSDS2 Docking Station |
|
|
Power |
(1) green LED, indicates operating power supplied from external power pack |
| Power Requirements |
|
|
Power Pack for MP-FS-RX1 Receiver |
2.0 Amps @ 24 Volts DC;
100-240 Volts AC, 50/60 Hz power pack, model PW-2420RU included |
|
|
Power Pack for MP-FSDS2 Docking Station |
1.2 Amps @ 5 Volts DC;
100-240 Volts AC, 50/60 Hz power pack, model PW-0510WU included |
| Battery – MP-FSMIC Microphone |
|
|
Battery Type |
Lithium Ion Polymer, 3.7 Volt, 180 mAh |
|
|
Usage per Charge |
6 hours |
|
|
Charging Time |
2 hours |
|
|
Cycle Life |
>500 cycles (80% capacity) |
| Environmental |
|
|
Temperature |
41° to 104°F (5° to 40°C) |
|
|
Humidity |
10% to 90% RH (non-condensing) |
|
|
Heat Dissipation |
35 BTU/Hr |
| Enclosure |
|
|
MP-FS-RX1 Receiver |
Aluminum chassis w/plastic faceplate and polycarbonate label overlay, freestanding |
|
|
MP-FSIR IR Beacon Sensor |
Plastic, matte white, mounts to ceiling or other flat surface |
|
|
MP-FSMIC Microphone |
Plastic, matte black, includes magnetic clip for lapel or lanyard attachment |
|
|
MP-FSDS2 Docking Station |
Plastic, matte black, weighted base |
| Dimensions |
|
|
MP-FS-RX1 Receiver |
Height: 2.36 in (60 mm);
Width: 8.12 in (207 mm);
Depth: 5.95 in (151 mm) |
|
|
MP-FSIR IR Beacon Sensor |
Height: 1.25 in (32 mm);
Diameter: 4.34 in (111 mm) |
|
|
MP-FSMIC Microphone |
Height: 2.09 in (54 mm);
Width: 1.00 in (26 mm);
Depth: 0.94 in (24 mm) |
|
|
MP-FSDS2 Docking Station |
Height: 0.90 in (23 mm);
Width: 3.00 in (77 mm);
Depth: 1.70 in (44 mm) |
| Weight |
|
|
MP-FS-RX1 Receiver |
2.30 lb (1.05 kg) |
|
|
MP-FSMIC Microphone |
0.7 oz (20 g) |
|
|
MP-FSDS2 Docking Station |
2.1 oz (60 g) |
|
|
MP-FSIR IR Beacon Sensor |
3.3 oz (92 g) |
